![]() ![]() The instructions are the same as the Cobra 25 above,EXCEPT the following:ġ. Remove R123 and replace with a jumper.ĬAUTION!!! I do not know if both of these power mods can be done at the same time!!! ![]() Remove final and replace with a 2SC1969 transistor.Ģ. Re-tune L14,L13,L12 for maximum forward power.ġ. OVERMOD: Check for missing or cut D9, missaligned VR5.ģ. Burned R89(15 Ohm 1/2 watt): Replace with a 1 watt.Ģ. LED goes out and NO TX when keyed up: Check C118ġ. NO TX: Check for shorted 33uF(10v) capacitor across C87.Ģ. Channel display reads all 7's or 8's: Leaky/shorted C104(470uF 10v). Place the two wires from the RF gain control in your mod kit by soldering one wire to each of the 220uF capacitors leads.ġ. Solder in a jumper wire from where you removed the wires on the board. Find the two wires that are attached to the RF gain control, follow them to the PC board and UNSOLDER them.Ģ. You can use different resistor values to get the desired dead-key.ġ. On the solder side of the board, solder the resistor across the 220uF capacitor. In JP6 holes, solder the 220uF capacitor. PARTS NEEDED: 1- 220uF (16 to 25 volt) electrolytic capacitor.ġ- 100 to 200 Ohm resistor. Re-tune coils L10,L9,L8 for maximum forward power. Replace stock final with a 2SC1969 transistor.ĥ. Change R76 (3.3k) to a 1k (located near mike socket)Ĥ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |